Thursday, October 16, 2008

Hard Drive

Time: 60 minutes

MediumReplacing
a laptop's hard drive is almost always an uncomplicated affair, and the
actual swap can be done in just a few minutes. Transferring the data
from the old drive to the new one requires a little more planning, and
typically takes an hour or so. This simple task is likely not only to
give you more storage, but also to improve performance. We upgraded a
5400-rpm, 120GB drive to a 7200-rpm, 200GB model, raising the system's
WorldBench 6 score from 57 to 61.

You can find a selection of laptop hard drives from a variety of vendors in PC World.ca Shopping.

Remove DriveHard
drives are usually accessible via a side panel in your laptop and held
in place by screws on the bottom. Remove those screws, and then slide
the drive out of the machine (as in photo 1 here).

The drive will
most likely be attached to a sled (photo 2, at left). Remove the screws
that are holding the drive in the sled, and remove the drive. Put the
new drive where the old one was, and replace all of the screws in
reverse order.

Remove Drive 2If
you are reinstalling Windows from scratch, boot from your installation
disc and go to town. On the other hand, if you want to reproduce your
old data and programs exactly the way you had them before, consider
using cloning software to make an exact copy of the old disk. We've had
great success with Clonezilla,
a free tool that is command-line only but is reasonably intuitive and
very fast. Finally, clone your old (now external) drive to your new
(now internal) drive, and boot normally. You're done.


Optical Drive

Time: 5 to 20 minutes

CD to DVDWould
you like to graduate from an older CD-ROM drive to a DVD burner, or
possibly even to a high-def drive? If your laptop has a modular optical
drive bay (one that is equipped with an ejector switch of some kind),
replacing your optical drive is easy. Buy a replacement drive, or
salvage one from a compatible machine. With the laptop turned off,
eject the old drive and then install the new one (photo 1, above right).

If
your laptop does not have a modular drive bay, replacement usually
remains fairly simple, anyway: Often a single locking screw holds the
drive in place; you just unscrew it, slide the old drive out, put in
the new drive, and replace the screw. In addition, you may need to
install any drivers that came with the new drive.

A replacement
drive should be designed for use with your specific notebook, so buy
one directly from the system's original manufacturer if possible. The
advantages? For one thing, this ensures that you'll have the correct
IDE channel settings (which often cannot be changed) for the drive; for
another, attaching the faceplate to the drive can be difficult, and
it's easy to break the faceplate when removing the original drive.
Vendors put the eject button in different places, too, meaning that
with the wrong drive you won't be able to use the faceplate at all.

In
many instances a new optical drive will work without additional
tweaking. If yours doesn't work, however, download the appropriate
driver; you may have to search on the full model number of the part if
you didn't obtain the drive from your notebook's vendor.

No comments: